The BESS Exchange is sponsored by Edge On Up › BESS Forums › Edge Sharpness Testing v
Deburring

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Deburring
Rupert Lucius Offline
Member
***
Posts: 260
Threads: 13
Joined: Mar 2017
#19
06-01-2017, 06:04 PM
No pressure - if any very very light.

Looking at the wheel (end view) about the 10 AM position.  All we want to cover is the cutting edge.

Persistent
Find
Reply


Messages In This Thread
Deburring - by grepper - 05-27-2017, 10:11 PM
RE: Deburring - by Rupert Lucius - 05-27-2017, 11:08 PM
RE: Deburring - by grepper - 05-27-2017, 11:32 PM
RE: Deburring - by Rupert Lucius - 05-28-2017, 08:22 AM
RE: Deburring - by grepper - 05-31-2017, 10:11 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 05:33 AM
RE: Deburring - by Jan - 05-28-2017, 07:25 AM
RE: Deburring - by grepper - 05-28-2017, 11:39 AM
RE: Deburring - by Jan - 05-28-2017, 03:22 PM
RE: Deburring - by grepper - 05-28-2017, 03:59 PM
RE: Deburring - by Jan - 05-29-2017, 01:27 AM
RE: Deburring - by grepper - 06-01-2017, 08:50 AM
RE: Deburring - by Rupert Lucius - 06-01-2017, 12:33 PM
RE: Deburring - by grepper - 06-01-2017, 12:40 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 02:16 PM
RE: Deburring - by grepper - 06-01-2017, 04:00 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 04:40 PM
RE: Deburring - by grepper - 06-01-2017, 05:07 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 06:04 PM
RE: Deburring - by grepper - 06-01-2017, 07:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)