The BESS Exchange is sponsored by Edge On Up › BESS Forums › Edge Sharpness Testing v
Deburring

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Deburring
grepper Offline
Administrator
*******
Posts: 947
Threads: 74
Joined: Mar 2017
Reputation: 0
#18
06-01-2017, 05:07 PM
Soft and fuzzy, eh?  Well, crap, Mr. Rupert!  I don't get it.   Huh

I stuck one on a hand drill and tested it.  Even considering it was slower than the RPM that you used, the thing did not remove burr well at all.  For me it was a dismal failure!  

I'll stick it on my bench grinder and see RPM makes a difference.  But I don't get it.  A real head scratcher.  

How much pressure do you use?  What angle to you apply the blade to the wheel?
Find
Reply


Messages In This Thread
Deburring - by grepper - 05-27-2017, 10:11 PM
RE: Deburring - by Rupert Lucius - 05-27-2017, 11:08 PM
RE: Deburring - by grepper - 05-27-2017, 11:32 PM
RE: Deburring - by Rupert Lucius - 05-28-2017, 08:22 AM
RE: Deburring - by grepper - 05-31-2017, 10:11 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 05:33 AM
RE: Deburring - by Jan - 05-28-2017, 07:25 AM
RE: Deburring - by grepper - 05-28-2017, 11:39 AM
RE: Deburring - by Jan - 05-28-2017, 03:22 PM
RE: Deburring - by grepper - 05-28-2017, 03:59 PM
RE: Deburring - by Jan - 05-29-2017, 01:27 AM
RE: Deburring - by grepper - 06-01-2017, 08:50 AM
RE: Deburring - by Rupert Lucius - 06-01-2017, 12:33 PM
RE: Deburring - by grepper - 06-01-2017, 12:40 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 02:16 PM
RE: Deburring - by grepper - 06-01-2017, 04:00 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 04:40 PM
RE: Deburring - by grepper - 06-01-2017, 05:07 PM
RE: Deburring - by Rupert Lucius - 06-01-2017, 06:04 PM
RE: Deburring - by grepper - 06-01-2017, 07:57 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)