03-24-2017, 09:54 AM
Got it.
Don't try to remove much of the wheel at once with the diamond dresser. You can damage it if you really plow into the stone. I say that from personal experience.
!
Possibly something like this might work to do most of the work, and then change to the Tormek dresser at the very end:
https://www.amazon.com/POWERTEC-71003-Di...B00B10LM6O
Even though it may take some time, it's always best to take off minimal amounts at a time with the dresser.
I remember reading about one guy who actually cut a wheel in half so that it was only 1" thick instead of 2" using a cutoff wheel. I know that's not what you are trying to do, but possibly some sort of powered solution might work.
Don't try to remove much of the wheel at once with the diamond dresser. You can damage it if you really plow into the stone. I say that from personal experience.
!Possibly something like this might work to do most of the work, and then change to the Tormek dresser at the very end:
https://www.amazon.com/POWERTEC-71003-Di...B00B10LM6O
Even though it may take some time, it's always best to take off minimal amounts at a time with the dresser.
I remember reading about one guy who actually cut a wheel in half so that it was only 1" thick instead of 2" using a cutoff wheel. I know that's not what you are trying to do, but possibly some sort of powered solution might work.