03-24-2017, 07:56 AM
Dan
I, defer to Ken and or gepper.
Yes, Rupert visualizes the damage and the problem.
In the past have had chips on the corner the corner of wheel.
The best thing would be to let the shipper know and make the decision?
That damage being on the 10 inch diameter of your wheel - that represents a great deal of lost sharpening surface.
Other than the cosmetic issue - keeping the wheel true in cir and etc., go sharpening try not to see damage. Hard to think about wasting that much wheel and/or diameter of your 10 inches?
Rupert
I, defer to Ken and or gepper.
Yes, Rupert visualizes the damage and the problem.
In the past have had chips on the corner the corner of wheel.
The best thing would be to let the shipper know and make the decision?
That damage being on the 10 inch diameter of your wheel - that represents a great deal of lost sharpening surface.
Other than the cosmetic issue - keeping the wheel true in cir and etc., go sharpening try not to see damage. Hard to think about wasting that much wheel and/or diameter of your 10 inches?
Rupert