12-16-2017, 11:02 PM
final sharpening is done after hardening and tempering. with thin stock, 1/16" or less, I oil quench to black then put between plates in a vise till a room temperature which helps prevent warping.
The BESS Exchange is sponsored by Edge On Up
›
BESS Forums
›
Knife Making & Bladesmithing in Memory of Mark Reich
Order of hardening and sharpening
Order of hardening and sharpening
Thread Rating:
|
Order of hardening and sharpening
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Order of hardening and sharpening - by grepper - 12-15-2017, 06:35 PM
RE: Order of hardening and sharpening - by wadebevan - 12-16-2017, 11:05 AM
RE: Order of hardening and sharpening - by scott.livesey - 12-16-2017, 11:02 PM
RE: Order of hardening and sharpening - by Mark Reich - 12-18-2017, 10:48 AM
|
Users browsing this thread: 1 Guest(s)