10-20-2020, 11:04 AM
"I take up the slack in the filament without tugging hard, and then tighten the clamp nut."
You got it! That is proper procedure.
"I find that when placing the ATF into its cut out, it is possible for it to get caught up on the metal plate."
Yeah. I've seen that too. The rubber boot on the bottom of the ATF can rub on the edge of the top plate if the ATF is not centered in the cutout. It would be nice if the cutout was of larger diameter. It wouldn't be too hard to grind the cutout to be a bit larger if you cared enough to bother with it.
You got it! That is proper procedure.
"I find that when placing the ATF into its cut out, it is possible for it to get caught up on the metal plate."
Yeah. I've seen that too. The rubber boot on the bottom of the ATF can rub on the edge of the top plate if the ATF is not centered in the cutout. It would be nice if the cutout was of larger diameter. It wouldn't be too hard to grind the cutout to be a bit larger if you cared enough to bother with it.