05-31-2019, 07:04 PM
(05-31-2019, 09:55 AM)EOU Wrote: Thanks Jan or maybe what some would call a wire edge Sharpco. Some straight edge guys tell us that some straight edge guys create and then shave with wire edges. No opinion on that assertion from us. Here's a picture taken at 400X by one of these customers. By our calculation the notch created is about .2mm deep or about the diameter of the test media.
The challenge, should you elect to accept it, Sharpco is this: We know that structurally sound edges measuring 10 on the Bess can and are created. If you could determine what does and does not work with straight razors it would be very beneficial to a number of people. Perhaps the solution is just as simple as Jan proposes or perhaps there are other elements to this as well.
Thank you EOU
