The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Toothy edge with Atoma 140 grit

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Toothy edge with Atoma 140 grit
SHARPCO Offline
Member
***
Posts: 219
Threads: 65
Joined: Jan 2018
#3
04-14-2019, 06:17 PM
Thank you for checking the LOW. 


I tried more stropping to remove it but the result of it was wearing the tooth. 

Anyway, this toothy edge was very impressive. It cut more easily than polished sharper edge.
Find
Reply


Messages In This Thread
Toothy edge with Atoma 140 grit - by SHARPCO - 04-14-2019, 01:44 AM
RE: Toothy edge with Atoma 140 grit - by grepper - 04-14-2019, 02:26 PM
RE: Toothy edge with Atoma 140 grit - by SHARPCO - 04-14-2019, 06:17 PM
RE: Toothy edge with Atoma 140 grit - by grepper - 04-14-2019, 08:53 PM
RE: Toothy edge with Atoma 140 grit - by SHARPCO - 04-15-2019, 10:21 PM
RE: Toothy edge with Atoma 140 grit - by grepper - 04-15-2019, 10:30 PM
RE: Toothy edge with Atoma 140 grit - by grepper - 04-15-2019, 10:50 PM
RE: Toothy edge with Atoma 140 grit - by SHARPCO - 04-15-2019, 11:28 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)