The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Second toothy edge

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Second toothy edge
SHARPCO Offline
Member
***
Posts: 219
Threads: 65
Joined: Jan 2018
#1
02-05-2019, 06:28 PM (This post was last modified: 02-05-2019, 06:28 PM by SHARPCO.)
This is my second toothy edge. 


   
120 grit Norton Blaze

   
3M Scotch Brite belt Medium - 1 pass each side
and 
3M Scotch Brite belt very fine - 3 pass each side

   
Clean leather belt - 5 pass each side

   
Draw the edge through a wood block - 15 times




I think that if I make a toothy edge with a belt grinder, the blade must be wear out quickly.(My belt grinder Viel S5 is faster than Kally.) So I'll make toothy edge with 140 grit Atoma next time.
Find
Reply


Messages In This Thread
Second toothy edge - by SHARPCO - 02-05-2019, 06:28 PM
RE: Second toothy edge - by grepper - 02-05-2019, 08:20 PM
RE: Second toothy edge - by SHARPCO - 02-05-2019, 09:50 PM
RE: Second toothy edge - by grepper - 02-05-2019, 10:37 PM
RE: Second toothy edge - by SHARPCO - 02-05-2019, 11:07 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)