01-27-2019, 01:11 AM
Thank you all.
I had a curiosity about the toothy edge. But my customers don't particularly like it. Most people like shiny and sharp edges.(If they try it, their thoughts may change.)
So I think shiny toothy edge will be a good solution. Wouldn't it be possible to make a micro toothy edge using a diamond abrasive? I'll try to remove the burr with Tormek honing compound and finish with diamond emulsion by hand stropping.
I had a curiosity about the toothy edge. But my customers don't particularly like it. Most people like shiny and sharp edges.(If they try it, their thoughts may change.)
So I think shiny toothy edge will be a good solution. Wouldn't it be possible to make a micro toothy edge using a diamond abrasive? I'll try to remove the burr with Tormek honing compound and finish with diamond emulsion by hand stropping.