The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Burr Free Sharpening Technique

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Burr Free Sharpening Technique
KnifeGrinders Offline
Knife Grinders
***
Posts: 287
Threads: 34
Joined: Oct 2017
#3
09-30-2018, 02:56 PM (This post was last modified: 09-30-2018, 03:19 PM by KnifeGrinders.)
"burr-free sharpening" is a fancy term for edge-leading sharpening.
"most straight razor honers" change from edge-leading to edge-trailing on grits finer than #4000 because they know too well that the edge micro-chipping characteristic of edge-leading technique won't allow them to get a fine razor edge.
http://knifeGrinders.com.au
Website Find
Reply


Messages In This Thread
Burr Free Sharpening Technique - by jasonstone20 - 09-30-2018, 12:00 PM
RE: Burr Free Sharpening Technique - by grepper - 09-30-2018, 02:47 PM
RE: Burr Free Sharpening Technique - by KnifeGrinders - 09-30-2018, 02:56 PM
RE: Burr Free Sharpening Technique - by grepper - 09-30-2018, 03:04 PM
RE: Burr Free Sharpening Technique - by SteveG - 09-30-2018, 05:39 PM
RE: Burr Free Sharpening Technique - by Jan - 10-01-2018, 06:48 AM
RE: Burr Free Sharpening Technique - by Jan - 10-02-2018, 02:18 AM
RE: Burr Free Sharpening Technique - by SteveG - 10-02-2018, 10:40 AM
RE: Burr Free Sharpening Technique - by SteveG - 10-02-2018, 01:27 PM
RE: Burr Free Sharpening Technique - by SteveG - 10-02-2018, 08:31 PM
RE: Burr Free Sharpening Technique - by SteveG - 10-03-2018, 12:10 PM
RE: Burr Free Sharpening Technique - by SteveG - 10-05-2018, 10:14 PM
RE: Burr Free Sharpening Technique - by grepper - 10-01-2018, 10:34 PM
RE: Burr Free Sharpening Technique - by Jan - 10-03-2018, 09:11 AM
RE: Burr Free Sharpening Technique - by SteveG - 10-03-2018, 12:08 PM
RE: Burr Free Sharpening Technique - by Jan - 10-04-2018, 02:12 AM
RE: Burr Free Sharpening Technique - by SteveG - 10-05-2018, 10:27 PM
RE: Burr Free Sharpening Technique - by Jan - 10-06-2018, 02:55 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)