The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
BESS value vs apex angle

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
BESS value vs apex angle
Cyrano Offline
Junior Member
**
Posts: 31
Threads: 4
Joined: Jun 2018
#1
08-25-2018, 10:57 AM
I've not yet achieved BESS values below 200 for edges with obtuse apex angles, e.g., 30 dps or greater.

Versus acute edges, I'm guessing obtuse edges require greater precision at all stages in the sharpening protocol, for similar reasons as why obtuse edges have poorer edge retention ... but that's just speculation on my part.

What are the best BESS scores folks have achieved for highly obtuse apex angles?
Find
Reply


Messages In This Thread
BESS value vs apex angle - by Cyrano - 08-25-2018, 10:57 AM
RE: BESS value vs apex angle - by KnifeGrinders - 08-26-2018, 04:23 PM
RE: BESS value vs apex angle - by Cyrano - 08-26-2018, 05:36 PM
RE: BESS value vs apex angle - by KnifeGrinders - 08-26-2018, 08:22 PM
RE: BESS value vs apex angle - by SteveG - 10-27-2018, 12:32 PM
RE: BESS value vs apex angle - by KnifeGrinders - 10-28-2018, 03:06 AM
RE: BESS value vs apex angle - by SteveG - 10-28-2018, 06:14 PM
RE: BESS value vs apex angle - by KnifeGrinders - 10-31-2018, 01:18 AM
RE: BESS value vs apex angle - by SteveG - 10-31-2018, 01:40 PM

Forum Jump:


Users browsing this thread: