Viel conversion motors now available

[Ken S]

I checked on the Penn State Industries website yesterday. The variable speed motors are now back in stock. 

Ken

[Rupert Lucius]

I checked on the Penn State Industries website yesterday. The variable speed motors are now back in stock. 

Ken

We will order one for whatever (inventory or etc) they are handy little fellows to have around when need arises.

Ken will you please publish the two part numbers?

Thanks

[Ken S]

Rupert,
The motors work very well. Purchasing one can be problematic. I suggest planning ahead. Penn State Industries runs frequent sales or free shipping. The motors are not always in stock. Complete unit or parts? Each has pros and cons. The kit sells for $119. That is higher than the parts. According to PSI service, the kit motor has a two year warranty, which, for some reason, the parts do not include. The kit includes the mounting lever, which can be useful for those who need to drill their own motor holes. I had to do this with my Gen II conversion and my Kally conversion. Actually, my Gen II conversion used this mounting lever instead of a mounting plate.

The main con with the kit is removing the multistep pulley. With a good gear puller and a center punch this is not difficult. Without one, it is a real pain.

I am not sure if the parts come with the mounting bolts and washers. These are standard M6 hardware store parts.

The other benefit of the kit is being able to order it online. If you decide to go the parts route, prepare for a long call. The service people are friendly and helpful, however, they seem understaffed. Get comfortable before you call and expect the helpful service person to recommend getting a kit. I have ordered three of these motors. All have been kits. 

I like the motors. Once you get one installed, you are past the hassles. If you are fortunate enough to get one of the two remaining units from sharpeningmadeeasy.com with the superb ready made plate, you are most fortunate. They are excellent and your work is much reduced.

Below are the parts numbers.

Ken

ZTCLVS-70  MOTOR $50
ZTCL-MCB  CONTROLLER $45

[Mike Brubacher]

Ken and Rupert. I have a simple resolution for your Viel power problems. It's economical to operate, eco-friendly and will give you something to do when its too windy to fish.

   

[Rupert Lucius]

Ken and Rupert. I have a simple resolution for your Viel power problems. It's economical to operate, eco-friendly and will give you something to do when its too windy to fish.

Great looking windmill photo -

Rupert