06-18-2017, 09:18 PM
(This post was last modified: 06-18-2017, 10:18 PM by Rupert Lucius.)
This past week I, realized that I needed to replace two Tormek 10" wheels.
Called Grizzley parts and asked the price for their 10" wheel parts number T20683 for Grizzly "want to be a Tormek" T10010) 39.95 plus shipping 9.99 total delivered 49.94$.
Used it today the 12 mm shaft hole perfect for the Tormek, removed the paper label from one side of the wheel and was a able to catch two threads on the Tormek shaft. Worked AOK!
Tested it on a dull 9 inch 440C chef knife at 15* - the sharpened edge was toothy enough for me (approximate to belt grit 120 minus).
Created a burr that I have not tried to removed. Did straighten said burr on a cotton buff. Ken's modified Viel running a leather belt in low gear would be perfect for said removal.
Approaching fresh harvested tomatoes laying on our kitchen table - they ALL jumped off the table.
Another bargain - my opinion.
Will order the second wheel tomorrow.
Rupert
Called Grizzley parts and asked the price for their 10" wheel parts number T20683 for Grizzly "want to be a Tormek" T10010) 39.95 plus shipping 9.99 total delivered 49.94$.
Used it today the 12 mm shaft hole perfect for the Tormek, removed the paper label from one side of the wheel and was a able to catch two threads on the Tormek shaft. Worked AOK!
Tested it on a dull 9 inch 440C chef knife at 15* - the sharpened edge was toothy enough for me (approximate to belt grit 120 minus).
Created a burr that I have not tried to removed. Did straighten said burr on a cotton buff. Ken's modified Viel running a leather belt in low gear would be perfect for said removal.
Approaching fresh harvested tomatoes laying on our kitchen table - they ALL jumped off the table.
Another bargain - my opinion.
Will order the second wheel tomorrow.
Rupert