Thanks, Rupert.
I sent USA Knifemaker an email. I will check local glass and fireplace stores.
Incidentally, my Viel project is progressing. Today I cut and fit the two Baltic birch ply sides which will hold the motor control. I drilled and countersank the four flathead machine screws which will hold the motor control. I have a few holes to locate and drill. Cut the dado for the cross piece and assemble.
I will add the "sine blocks" later to control the belt angle. As Max says, "Stay tuned".
Ken
I sent USA Knifemaker an email. I will check local glass and fireplace stores.
Incidentally, my Viel project is progressing. Today I cut and fit the two Baltic birch ply sides which will hold the motor control. I drilled and countersank the four flathead machine screws which will hold the motor control. I have a few holes to locate and drill. Cut the dado for the cross piece and assemble.
I will add the "sine blocks" later to control the belt angle. As Max says, "Stay tuned".
Ken