04-19-2023, 11:35 AM
For any measurement method, it is important to apply an established measurement protocol.
For example, for outdoor temperature measurements, it was once agreed that this is done at 1.5 meters above the ground, in a cabin painted white, where the wind can blow through and the sun cannot penetrate, etc.
Is there also such a protocol for BESS measurements?
I ask about this because I saw a video on FB that a BESS device is a waste of money. If you press the wire quickly you get a lower reading, than if you press the wire very slowly.
Would like your response.
For example, for outdoor temperature measurements, it was once agreed that this is done at 1.5 meters above the ground, in a cabin painted white, where the wind can blow through and the sun cannot penetrate, etc.
Is there also such a protocol for BESS measurements?
I ask about this because I saw a video on FB that a BESS device is a waste of money. If you press the wire quickly you get a lower reading, than if you press the wire very slowly.
Would like your response.