08-11-2022, 07:24 PM
While EOU is very responsive to and appreciates user feedback, any change in product design is going to take some time.
Here are a couple of suggestions on how you could solve the issue yourself quickly and easily.
1. Get some grip tape and stick it to the bottom of the DCB10. This one is just a suggestion. There are lots of different grip tapes available. Just be aware that some tapes are more to prevent slipping from your fingers but will still slide on surfaces. Sand paper would be an example. Very grippy to fingers but will still slide on a surface. Other tapes resist surface sliding. I have some of the below linked to product. Available in strips or rolls. Here it is stuck to the bottom of my phone. As you can see, it is very resistant to sliding on surfaces.
https://www.amazon.com/CatTongue-Grips-A...215&sr=1-4
2. Get a neodymium disc magnet. Drill a small recess in the bottom of the DCB10 and Super Glue the magnet in. Something like one of the these. 0.125" thick, 2.25 - 6.5 lb pull available.
https://www.magnetshop.com/neodymium-dis...ets.html#1
Here are a couple of suggestions on how you could solve the issue yourself quickly and easily.
1. Get some grip tape and stick it to the bottom of the DCB10. This one is just a suggestion. There are lots of different grip tapes available. Just be aware that some tapes are more to prevent slipping from your fingers but will still slide on surfaces. Sand paper would be an example. Very grippy to fingers but will still slide on a surface. Other tapes resist surface sliding. I have some of the below linked to product. Available in strips or rolls. Here it is stuck to the bottom of my phone. As you can see, it is very resistant to sliding on surfaces.
https://www.amazon.com/CatTongue-Grips-A...215&sr=1-4
2. Get a neodymium disc magnet. Drill a small recess in the bottom of the DCB10 and Super Glue the magnet in. Something like one of the these. 0.125" thick, 2.25 - 6.5 lb pull available.
https://www.magnetshop.com/neodymium-dis...ets.html#1