The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Forging / smithing

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Forging / smithing
Jan Offline
Senior Member
****
Posts: 361
Threads: 11
Joined: Mar 2017
#7
04-24-2017, 02:10 AM (This post was last modified: 04-24-2017, 02:11 AM by Jan.)
Yes, Mr. Mark, you are correct!

Good hammer and steel ball rebound are necessary anvil face properties.
Anvil ringing is also very important. Cracked pot sound indicates structural defects. On the other hand very loud anvil response is annoying. Wink


Find
Reply


Messages In This Thread
Forging / smithing - by wadebevan - 04-14-2017, 01:23 PM
RE: Forging / smithing - by Mark Reich - 04-17-2017, 02:11 PM
RE: Forging / smithing - by wadebevan - 04-18-2017, 07:43 PM
RE: Forging / smithing - by Mark Reich - 04-21-2017, 06:55 PM
RE: Forging / smithing - by Jan - 04-22-2017, 09:59 AM
RE: Forging / smithing - by Mark Reich - 04-23-2017, 09:26 PM
RE: Forging / smithing - by Jan - 04-24-2017, 02:10 AM
RE: Forging / smithing - by Mark Reich - 04-24-2017, 07:27 AM
RE: Forging / smithing - by Jan - 04-24-2017, 01:00 PM
RE: Forging / smithing - by Mark Reich - 04-25-2017, 04:37 PM
RE: Forging / smithing - by Jan - 04-26-2017, 02:57 AM
RE: Forging / smithing - by Jan - 04-26-2017, 05:30 AM
RE: Forging / smithing - by Mark Reich - 04-26-2017, 10:22 AM
RE: Forging / smithing - by Jan - 04-26-2017, 01:45 PM
RE: Forging / smithing - by Mark Reich - 04-26-2017, 09:07 PM
RE: Forging / smithing - by Jan - 04-27-2017, 05:41 AM
RE: Forging / smithing - by Mark Reich - 04-27-2017, 11:30 AM
RE: Forging / smithing - by Jan - 04-28-2017, 10:02 AM
RE: Forging / smithing - by Mark Reich - 05-02-2017, 11:35 AM
RE: Forging / smithing - by Jan - 05-09-2017, 06:18 AM
RE: Forging / smithing - by Jan - 05-02-2017, 01:01 PM
RE: Forging / smithing - by Mark Reich - 05-11-2017, 07:46 AM
RE: Forging / smithing - by Jan - 05-11-2017, 01:53 PM
RE: Forging / smithing - by Jan - 05-14-2017, 05:17 AM
RE: Forging / smithing - by Mark Reich - 05-24-2017, 09:30 AM
RE: Forging / smithing - by Jan - 05-24-2017, 01:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)