03-12-2021, 07:18 AM
@knifegrinders
Thank you for taking the time to reply. I agree that this is a good solution. I found the fine Diamond rod (approx 1000) to work very well but leave visible scratch pattern on the edge, so will try an ultra fine Diamond (approx 1800 grit). I take it I should probably go edge leading on the rod for optimal burr formation?
Thank you for taking the time to reply. I agree that this is a good solution. I found the fine Diamond rod (approx 1000) to work very well but leave visible scratch pattern on the edge, so will try an ultra fine Diamond (approx 1800 grit). I take it I should probably go edge leading on the rod for optimal burr formation?