04-16-2020, 08:49 PM
I have both the long and regular knife jigs and would gladly give you either, but unfortunately both are post 2001. Best of luck finding a jig 18+ years old! Ebay maybe?
Another option would be to cut the shorter shaft and then have an extension section welded in the middle to make it longer. Or... cut the shaft, get a die, thread the ends and use a female threaded spacer like the one below to reconnect the cut shaft sections to the desired length.
https://www.mcmaster.com/standard-thread...andoffs-6/
Your local machine shop could easily do either, I guess it just depends on how important the project is for you.
BTW, Hi Mr. Ken!
Another option would be to cut the shorter shaft and then have an extension section welded in the middle to make it longer. Or... cut the shaft, get a die, thread the ends and use a female threaded spacer like the one below to reconnect the cut shaft sections to the desired length.
https://www.mcmaster.com/standard-thread...andoffs-6/
Your local machine shop could easily do either, I guess it just depends on how important the project is for you.
BTW, Hi Mr. Ken!