04-08-2020, 02:12 PM
(04-08-2020, 09:54 AM)Mike Brubacher Wrote: The handle was so impregnated with grease that I never could get it clean though. I suspect that it was used in a butcher shop. I'm going to retrieve it back to the office and give it your Kally treatment. I'll let you know how it turns out.
Neat!
You probably don't need my advice, but... The kally with a 120 grit belt will consume wood at a pretty fast pace. It's not crazy, but it definitely removes a good bit of material in a short time. For reshaping it's pretty friendly. Depending on how deep the oil/grease goes, you might try 100 grit sandpaper by hand first. If you are careful I'm sure that the Kally will work. Either way I would finish sanding by hand.
I'll be very curious to hear about your results. Good luck!
Brian.