08-12-2019, 02:20 PM
"Go for it"
The 6" wheel would be spot on for my blade sharpening.
Rupert
The 6" wheel would be spot on for my blade sharpening.
Rupert
The BESS Exchange is sponsored by Edge On Up
›
BESS Forums
›
Relevant General Discussion
Possible to use a Work Sharp 3000 motor to power a Viel S5?
Possible to use a Work Sharp 3000 motor to power a Viel S5?
Thread Rating:
|
Possible to use a Work Sharp 3000 motor to power a Viel S5?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Possible to use a Work Sharp 3000 motor to power a Viel S5? - by carbon - 08-12-2019, 10:19 AM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by Rupert Lucius - 08-12-2019, 02:20 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by Mark Reich - 08-12-2019, 02:35 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by carbon - 08-12-2019, 06:35 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by carbon - 08-12-2019, 06:48 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by Mark Reich - 10-14-2019, 03:14 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by carbon - 10-14-2019, 06:52 PM
RE: Possible to use a Work Sharp 3000 motor to power a Viel S5? - by Mark Reich - 10-15-2019, 01:04 PM
|
Users browsing this thread: 1 Guest(s)