The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Chinese Cleavers

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Chinese Cleavers
EOU Offline
Senior Member
****
Posts: 500
Threads: 38
Joined: Mar 2017
#20
08-08-2019, 09:27 AM
That's a substantial looking piece Bud! Thanks to ken123 for reviving this thread. It seems that most new cutting edges can benefit from additional burr removal efforts. Your cleaver appears to be no different than most.
Find
Reply


Messages In This Thread
Chinese Cleavers - by Sam Sloane - 03-18-2019, 04:25 PM
RE: Chinese Cleavers - by Mike Brubacher - 03-19-2019, 09:37 AM
RE: Chinese Cleavers - by Ken S - 03-20-2019, 04:55 AM
RE: Chinese Cleavers - by Mark Reich - 03-20-2019, 12:35 PM
RE: Chinese Cleavers - by Ken S - 03-20-2019, 02:11 PM
RE: Chinese Cleavers - by Mike Brubacher - 03-20-2019, 03:51 PM
RE: Chinese Cleavers - by Mike Brubacher - 03-20-2019, 04:44 PM
RE: Chinese Cleavers - by Sam Sloane - 03-20-2019, 07:47 PM
RE: Chinese Cleavers - by Bud - 03-20-2019, 08:02 PM
RE: Chinese Cleavers - by Mark Reich - 03-20-2019, 09:23 PM
RE: Chinese Cleavers - by grepper - 03-20-2019, 10:46 PM
RE: Chinese Cleavers - by Mark Reich - 03-22-2019, 11:34 AM
RE: Chinese Cleavers - by ken123 - 08-05-2019, 08:54 PM
RE: Chinese Cleavers - by Bud - 08-05-2019, 10:16 PM
RE: Chinese Cleavers - by ken123 - 08-06-2019, 02:42 AM
RE: Chinese Cleavers - by ken123 - 08-06-2019, 02:59 AM
RE: Chinese Cleavers - by Bud - 08-06-2019, 10:19 PM
RE: Chinese Cleavers - by carbon - 08-07-2019, 09:01 PM
RE: Chinese Cleavers - by Bud - 08-07-2019, 10:45 PM
RE: Chinese Cleavers - by EOU - 08-08-2019, 09:27 AM
RE: Chinese Cleavers - by Bud - 08-18-2019, 10:46 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)