07-10-2019, 06:40 PM
Guess I didn't just move on to using it. I do not plan on getting or using any of the Viel attachments, so I am setting up the Tormek BGM and FVB on this so I can use the Tormek jigs, primarily for knives, but I figure there will be some other tools that get put to it. The sander frame interferes with positioning of some of the jigs, so it is proving challenging to find a good setup.
Also, I just couldn't stand those two little spring loaded screws that are supposed to serve as tracking adjustment. I had to change them out for nylon set screws with a jam nut for locking their positions. I also added two down towards the bottom of the plunger for greater control. The new setup is actually making a difference. Tracking is substantially improved AND the plunger rises and falls more easily, whereas at least before the plunger did not rise & fall smoothly or easily.
I had the 1/4-20 nylon set screws from another project and just had to get the thinner jam nuts. It also meant drilling out and tapping for 1/4-20. I was a little concerned about how thin the wall of the square tubing is, but there is enough to get about 1-3/4 turns in. I figure that is enough since there isn't a lot of tension on them, just vibration that could work them loose.
Rick
Also, I just couldn't stand those two little spring loaded screws that are supposed to serve as tracking adjustment. I had to change them out for nylon set screws with a jam nut for locking their positions. I also added two down towards the bottom of the plunger for greater control. The new setup is actually making a difference. Tracking is substantially improved AND the plunger rises and falls more easily, whereas at least before the plunger did not rise & fall smoothly or easily.
I had the 1/4-20 nylon set screws from another project and just had to get the thinner jam nuts. It also meant drilling out and tapping for 1/4-20. I was a little concerned about how thin the wall of the square tubing is, but there is enough to get about 1-3/4 turns in. I figure that is enough since there isn't a lot of tension on them, just vibration that could work them loose.
Rick