The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Building a Super Forge

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Building a Super Forge
wadebevan Offline
Member
***
Posts: 100
Threads: 11
Joined: Mar 2017
#5
04-10-2017, 11:21 AM
3" dia. round stock!!! Yeah, that would need a lot of heat.
I spent some time on the web this morning looking for 52100 steel in flat bar stock, not as common as I had hoped.

+1 on overkill Smile

(I could have built my fence out of 4x4 posts, but 6x6 treated posts will likely outlast me.)
Find
Reply


Messages In This Thread
Building a Super Forge - by Mark Reich - 04-09-2017, 10:29 PM
RE: Building a Super Forge - by Bubby - 04-10-2017, 08:29 AM
RE: Building a Super Forge - by wadebevan - 04-10-2017, 09:21 AM
RE: Building a Super Forge - by Mark Reich - 04-10-2017, 10:44 AM
RE: Building a Super Forge - by wadebevan - 04-10-2017, 11:21 AM
RE: Building a Super Forge - by Mark Reich - 04-10-2017, 01:25 PM
RE: Building a Super Forge - by Ken S - 04-10-2017, 06:21 PM
RE: Building a Super Forge - by Bubby - 04-11-2017, 09:23 AM
RE: Building a Super Forge - by Mark Reich - 04-11-2017, 10:54 AM
RE: Building a Super Forge - by Jan - 04-11-2017, 01:32 PM
RE: Building a Super Forge - by Mark Reich - 04-11-2017, 04:51 PM
RE: Building a Super Forge - by Jan - 04-12-2017, 05:29 AM
RE: Building a Super Forge - by Mark Reich - 04-12-2017, 11:50 AM
RE: Building a Super Forge - by Jan - 04-13-2017, 08:50 AM
RE: Building a Super Forge - by Jan - 04-12-2017, 03:32 PM
RE: Building a Super Forge - by Soxx - 04-15-2017, 01:42 PM
RE: Building a Super Forge - by Rupert Lucius - 04-15-2017, 02:38 PM
RE: Building a Super Forge - by Mark Reich - 04-17-2017, 10:12 AM
RE: Building a Super Forge - by pjwoolw - 04-17-2017, 03:40 PM
RE: Building a Super Forge - by Ken S - 04-17-2017, 06:00 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)