The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Hardness Testing a Knife

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Hardness Testing a Knife
grepper Offline
Administrator
*******
Posts: 945
Threads: 74
Joined: Mar 2017
Reputation: 0
#3
03-05-2019, 09:26 PM (This post was last modified: 03-05-2019, 09:27 PM by grepper.)
There... listen... crickets!

I don't have experience but I would assume, suspect (hope) that whoever was performing the test would square the knife with the indenter. I too would think that a glancing blow would not be ideal.

Is that what you were asking Mr. Sam?
Find
Reply


Messages In This Thread
Hardness Testing a Knife - by Sam Sloane - 03-04-2019, 08:39 AM
RE: Hardness Testing a Knife - by Sam Sloane - 03-05-2019, 06:34 PM
RE: Hardness Testing a Knife - by grepper - 03-05-2019, 09:26 PM
RE: Hardness Testing a Knife - by Mark Reich - 03-06-2019, 06:07 PM
RE: Hardness Testing a Knife - by Bud - 08-04-2019, 06:31 PM
RE: Hardness Testing a Knife - by songshun - 10-09-2020, 04:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)