The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › Knife Making & Bladesmithing in Memory of Mark Reich v
Hardness Testing a Knife

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Hardness Testing a Knife
Sam Sloane Offline
Junior Member
**
Posts: 25
Threads: 11
Joined: Jan 2018
#1
03-04-2019, 08:39 AM
Question to those that have experience.....

If I get a knife tested ( at the thickest part of the blade) does the included angle of the blade, even though it is very small, give results different than those of heat treated flat stock?

Thanks all,

Sam
Find
Reply


Messages In This Thread
Hardness Testing a Knife - by Sam Sloane - 03-04-2019, 08:39 AM
RE: Hardness Testing a Knife - by Sam Sloane - 03-05-2019, 06:34 PM
RE: Hardness Testing a Knife - by grepper - 03-05-2019, 09:26 PM
RE: Hardness Testing a Knife - by Mark Reich - 03-06-2019, 06:07 PM
RE: Hardness Testing a Knife - by Bud - 08-04-2019, 06:31 PM
RE: Hardness Testing a Knife - by songshun - 10-09-2020, 04:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)