02-20-2019, 02:47 PM
(02-20-2019, 01:50 PM)Jan Wrote: Sam, thanks for posting the results of your modelling.
Please can you repeat your calculations for an apex width of 100 nanometers, which is the expected apex width of DE razor blade? The included bevel angle is circa 15 degrees.
Jan
Jan,
if we are going to do this.....give me some more real world info......how think is a DE blade?....and its flat ( parallel surfaces) except for the bevel?....
15 degrees total included angle?
Also.....I am using a "fixture" in my model as the spine of the knife......in a DE razor, how far back from the apex would it be "fixtured" or held....
finally....how much force shall we apply over the std 25mm edge length?
Happy to do this and give something back....