The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Stress Levels in an edge....

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Stress Levels in an edge....
Jan Offline
Senior Member
****
Posts: 361
Threads: 11
Joined: Mar 2017
#2
02-20-2019, 01:50 PM
Sam, thanks for posting the results of your modelling. Smile 

Please can you repeat your calculations for an apex width of 100 nanometers, which is the expected apex width of DE razor blade? The included bevel angle is circa 15 degrees.
 
Jan


Find
Reply


Messages In This Thread
Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 08:04 AM
RE: Stress Levels in an edge.... - by Jan - 02-20-2019, 01:50 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 02:47 PM
RE: Stress Levels in an edge.... - by Jan - 02-21-2019, 05:56 AM
RE: Stress Levels in an edge.... - by EOU - 02-20-2019, 05:45 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 06:07 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-21-2019, 02:51 PM
RE: Stress Levels in an edge.... - by Jan - 02-22-2019, 02:29 AM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-22-2019, 04:33 AM
RE: Stress Levels in an edge.... - by Jan - 02-22-2019, 07:21 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)