The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Stress Levels in an edge....

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Stress Levels in an edge....
Sam Sloane Offline
Junior Member
**
Posts: 25
Threads: 11
Joined: Jan 2018
#1
Photo  02-20-2019, 08:04 AM
    Just bored this morning....so for fun, I ran some simple FEA on a knife blade section.

Standard width kitchen knife
Material: 1045 steel.....just because I had full properties
20 deg bevel
0.00005 in apex radius

Load over 1 inch......5lbf total

File attached.....
Find
Reply


Messages In This Thread
Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 08:04 AM
RE: Stress Levels in an edge.... - by Jan - 02-20-2019, 01:50 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 02:47 PM
RE: Stress Levels in an edge.... - by Jan - 02-21-2019, 05:56 AM
RE: Stress Levels in an edge.... - by EOU - 02-20-2019, 05:45 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-20-2019, 06:07 PM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-21-2019, 02:51 PM
RE: Stress Levels in an edge.... - by Jan - 02-22-2019, 02:29 AM
RE: Stress Levels in an edge.... - by Sam Sloane - 02-22-2019, 04:33 AM
RE: Stress Levels in an edge.... - by Jan - 02-22-2019, 07:21 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)