12 volt motor
|
12 volt motor
|
01-16-2019, 11:28 AM
Thanks, Ken! No belt sander should have an open vent design. I’m surprised that Viel hasn’t thought this through. I’ve spoken to the owner of Viel Tools a couple of times, and he seems to be open to suggestions. Their frame design is fantastic, but there is definitely room for improvement. A 12 volt motor would be a great start.
Garry. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
12 volt motor - by Ordener - 01-07-2019, 06:20 PM
RE: 12 volt motor - by SHARPCO - 01-08-2019, 06:09 AM
RE: 12 volt motor - by Ordener - 01-08-2019, 09:27 AM
RE: 12 volt motor - by Ken S - 01-08-2019, 10:27 AM
RE: 12 volt motor - by SHARPCO - 01-08-2019, 06:24 PM
RE: 12 volt motor - by Ken C - 01-08-2019, 11:48 AM
RE: 12 volt motor - by Ordener - 01-08-2019, 12:02 PM
RE: 12 volt motor - by Ken S - 01-08-2019, 02:46 PM
RE: 12 volt motor - by Ordener - 01-08-2019, 06:23 PM
RE: 12 volt motor - by Ken S - 01-08-2019, 08:31 PM
RE: 12 volt motor - by Ordener - 01-08-2019, 09:22 PM
RE: 12 volt motor - by Ken C - 01-09-2019, 10:56 AM
RE: 12 volt motor - by Mark Reich - 01-14-2019, 01:46 PM
RE: 12 volt motor - by Ordener - 01-14-2019, 03:00 PM
RE: 12 volt motor - by SHARPCO - 01-14-2019, 08:04 PM
RE: 12 volt motor - by Ken S - 01-15-2019, 01:35 AM
RE: 12 volt motor - by Ordener - 01-16-2019, 11:28 AM
RE: 12 volt motor - by SHARPCO - 01-16-2019, 06:38 PM
RE: 12 volt motor - by Ordener - 01-16-2019, 07:48 PM
RE: 12 volt motor - by Mark Reich - 01-17-2019, 11:39 AM
RE: 12 volt motor - by wadebevan - 01-18-2019, 01:39 PM
RE: 12 volt motor - by SHARPCO - 01-18-2019, 02:59 PM
RE: 12 volt motor - by wadebevan - 01-19-2019, 12:18 PM
RE: 12 volt motor - by Mark Reich - 01-20-2019, 11:26 AM
RE: 12 volt motor - by SHARPCO - 01-20-2019, 05:47 PM
RE: 12 volt motor - by grepper - 01-20-2019, 08:47 PM
RE: 12 volt motor - by SHARPCO - 01-20-2019, 10:13 PM
RE: 12 volt motor - by grepper - 01-20-2019, 11:01 PM
|
