The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
12 volt motor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
12 volt motor
Ken S Offline
Senior Member
****
Posts: 504
Threads: 55
Joined: Feb 2017
#10
01-08-2019, 08:31 PM
With the other motor, try to make sure that it is of a compatable size for the Viel. As I recall, the Viel is designed for NEMA 44 motors. (I planned to use motors I already had. They were all too large.)

Ken
Find
Reply


Messages In This Thread
12 volt motor - by Ordener - 01-07-2019, 06:20 PM
RE: 12 volt motor - by SHARPCO - 01-08-2019, 06:09 AM
RE: 12 volt motor - by Ordener - 01-08-2019, 09:27 AM
RE: 12 volt motor - by Ken S - 01-08-2019, 10:27 AM
RE: 12 volt motor - by SHARPCO - 01-08-2019, 06:24 PM
RE: 12 volt motor - by Ken C - 01-08-2019, 11:48 AM
RE: 12 volt motor - by Ordener - 01-08-2019, 12:02 PM
RE: 12 volt motor - by Ken S - 01-08-2019, 02:46 PM
RE: 12 volt motor - by Ordener - 01-08-2019, 06:23 PM
RE: 12 volt motor - by Ken S - 01-08-2019, 08:31 PM
RE: 12 volt motor - by Ordener - 01-08-2019, 09:22 PM
RE: 12 volt motor - by Ken C - 01-09-2019, 10:56 AM
RE: 12 volt motor - by Mark Reich - 01-14-2019, 01:46 PM
RE: 12 volt motor - by Ordener - 01-14-2019, 03:00 PM
RE: 12 volt motor - by SHARPCO - 01-14-2019, 08:04 PM
RE: 12 volt motor - by Ken S - 01-15-2019, 01:35 AM
RE: 12 volt motor - by Ordener - 01-16-2019, 11:28 AM
RE: 12 volt motor - by SHARPCO - 01-16-2019, 06:38 PM
RE: 12 volt motor - by Ordener - 01-16-2019, 07:48 PM
RE: 12 volt motor - by Mark Reich - 01-17-2019, 11:39 AM
RE: 12 volt motor - by wadebevan - 01-18-2019, 01:39 PM
RE: 12 volt motor - by SHARPCO - 01-18-2019, 02:59 PM
RE: 12 volt motor - by wadebevan - 01-19-2019, 12:18 PM
RE: 12 volt motor - by Mark Reich - 01-20-2019, 11:26 AM
RE: 12 volt motor - by SHARPCO - 01-20-2019, 05:47 PM
RE: 12 volt motor - by grepper - 01-20-2019, 08:47 PM
RE: 12 volt motor - by SHARPCO - 01-20-2019, 10:13 PM
RE: 12 volt motor - by grepper - 01-20-2019, 11:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)