Viel conversion
|
Viel conversion
|
01-06-2019, 12:32 PM
You are quite welcome. I forgot to mention, that if/when reaming, use a fairly low speed. If using a belt driven drill press, likely the lowest speed you can get. That size of hole, I would not be using high speed for the drilling either, but probably not as slow as for reaming.
Use cutting lubricant for both. Rick |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Viel conversion - by Ordener - 01-05-2019, 09:02 PM
RE: Viel conversion - by Rick Kr - 01-06-2019, 11:15 AM
RE: Viel conversion - by Ordener - 01-06-2019, 12:21 PM
RE: Viel conversion - by Rick Kr - 01-06-2019, 12:32 PM
RE: Viel conversion - by Ordener - 01-06-2019, 12:45 PM
RE: Viel conversion - by Ken S - 01-06-2019, 01:02 PM
RE: Viel conversion - by Ordener - 01-06-2019, 02:47 PM
|
