12-10-2018, 10:44 PM
I did a bit of searching around and found this:
https://www.google.com/url?sa=t&rct=j&q=...uLtjR0neGe
Directions for use:
1. For best performance bond surfaces should be clean and
free from grease.
2. To ensure a fast and reliable cure, Activator 7075™
should be applied to one of the bond surfaces and the
adhesive to the other surface. Parts should be assembled
within 15 minutes.
That said, from other searching around I think 324 will cure fine on it's own, but it may take a least a day or two to fully cure. I guess I'd do as Mr. Mark and the link suggests and use Activator 7075 to be sure.
https://www.google.com/url?sa=t&rct=j&q=...uLtjR0neGe
Directions for use:
1. For best performance bond surfaces should be clean and
free from grease.
2. To ensure a fast and reliable cure, Activator 7075™
should be applied to one of the bond surfaces and the
adhesive to the other surface. Parts should be assembled
within 15 minutes.
That said, from other searching around I think 324 will cure fine on it's own, but it may take a least a day or two to fully cure. I guess I'd do as Mr. Mark and the link suggests and use Activator 7075 to be sure.