Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KF-10R Screwed up Screws
#2
No big deal EOU. You may know that I ordered the new knife fulcrum primarily for the wider slot. Much better for all my heavier blades. I don't worry much about protecting the edge from plastic but still I like the rubber insert. I still use the old style for thinner blades. Mine wobbled just a bit so I screwed the screw out a little and then ground the head down just a bit on the Kally and screwed it back in. It was about a one minute fix so no biggy.
Reply


Messages In This Thread
KF-10R Screwed up Screws - by EOU - 10-03-2018, 04:42 PM
RE: KF-10R Screwed up Screws - by Bud - 10-08-2018, 07:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)