09-14-2018, 09:37 PM
(This post was last modified: 09-14-2018, 09:46 PM by KnifeGrinders.)
Knowledge of what does not work is as important and difficult to get as the positive.
Thanks to your tests, we can forget the plates and move to testing the pipe/rod that should show clearer the difference between the burr and a clean apex by reducing the contact area and increasing the load per point.
Funnily enough I was also thinking of S90V or S110V to begin with, but following your tests... you are right, ELMAX or S30V should be a better start.
Thanks to your tests, we can forget the plates and move to testing the pipe/rod that should show clearer the difference between the burr and a clean apex by reducing the contact area and increasing the load per point.
Funnily enough I was also thinking of S90V or S110V to begin with, but following your tests... you are right, ELMAX or S30V should be a better start.
http://knifeGrinders.com.au