The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 871 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 871 errorHandler->error



The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
The first impression of Viel S-5-M

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
The first impression of Viel S-5-M
SHARPCO Offline
Member
***
Posts: 219
Threads: 65
Joined: Jan 2018
#1
09-12-2018, 06:28 PM (This post was last modified: 09-12-2018, 06:29 PM by SHARPCO.)
   
This is my second belt grinder Viel S-5-M(1/3HP)


   
It's 4mm thick Robax ceramic glass. 


   
I applied Jende 4 micron & 0.5 micron PDP emulsion to linen belts, but it couldn't remove the burr.(Left is 0.5 micron, Right is 4 micron) 


   
So I tried to 4 micron PDP to Surgi-sharp leather belt, but the result was not different.(Right belt)

Left belt is Surgi-sharp applied with Tormek PA-70. It killed the burr and honed the edge very well. I can get 50~70 BESS with my kitchen knife. But I think 2700 SFM is too fast for using it.
Find
Reply


Messages In This Thread
The first impression of Viel S-5-M - by SHARPCO - 09-12-2018, 06:28 PM
RE: The first impression of Viel S-5-M - by Ken S - 09-13-2018, 09:20 AM
RE: The first impression of Viel S-5-M - by EOU - 09-13-2018, 03:00 PM
RE: The first impression of Viel S-5-M - by Ken S - 09-14-2018, 03:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)