The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Sharpness vs Cutting Ability

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Sharpness vs Cutting Ability
Larrin Offline
Junior Member
**
Posts: 41
Threads: 4
Joined: Jun 2018
#5
08-07-2018, 04:17 PM
Those were the edges tested in the paper, not a defined limit. What is the reference for the 0.05 micron radius?
Find
Reply


Messages In This Thread
Sharpness vs Cutting Ability - by Larrin - 08-06-2018, 10:33 AM
RE: Sharpness vs Cutting Ability - by EOU - 08-06-2018, 04:38 PM
RE: Sharpness vs Cutting Ability - by Larrin - 08-07-2018, 06:31 AM
RE: Sharpness vs Cutting Ability - by Jan - 08-07-2018, 09:02 AM
RE: Sharpness vs Cutting Ability - by Larrin - 08-07-2018, 04:17 PM
RE: Sharpness vs Cutting Ability - by Jan - 08-08-2018, 09:02 AM
RE: Sharpness vs Cutting Ability - by Jan - 08-08-2018, 07:22 AM
RE: Sharpness vs Cutting Ability - by Larrin - 08-08-2018, 09:25 AM
RE: Sharpness vs Cutting Ability - by Larrin - 08-08-2018, 10:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)