07-23-2018, 06:13 PM
Thank you very much for your generous offer, Thomas, that is super kind of you!
I didn't know you used to be on Knifeforums, Thomas. Maybe I just forget. That was the best sharpening forum by far IMHO. I had almost 6,000 posts by the time they let it die. I was crushed.
I've been using Rockler rare earth magnets for very many years, because they are so strong and heat resistant. They are round discs, and come in many sizes.
Mr. Rupert, I can make your EP table magnetic for you. I would use my mill to make exact holes with flat bottoms and perfect spacing in the under side of the EP table. I am kind of a stickler for details.
One cool thing about the magnets I use is that their strength adds up. I mean two 5 lb magnets stuck together makes a 10 lb magnet. I'm not sure if it's exactly double, but I think it is.
At any rate, you would think Ben Dale put them there himself.
I didn't know you used to be on Knifeforums, Thomas. Maybe I just forget. That was the best sharpening forum by far IMHO. I had almost 6,000 posts by the time they let it die. I was crushed.
I've been using Rockler rare earth magnets for very many years, because they are so strong and heat resistant. They are round discs, and come in many sizes.
Mr. Rupert, I can make your EP table magnetic for you. I would use my mill to make exact holes with flat bottoms and perfect spacing in the under side of the EP table. I am kind of a stickler for details.
One cool thing about the magnets I use is that their strength adds up. I mean two 5 lb magnets stuck together makes a 10 lb magnet. I'm not sure if it's exactly double, but I think it is.
At any rate, you would think Ben Dale put them there himself.