07-20-2018, 08:52 AM
Hi Rupert,
No, I man not a master - but I like to experiment with edges and what I can do with edges with my tools.
The picture above is from one of my experiments in precission grinding. It is 0,75 degrees angle between the fazets, the fazets are about 1 mm wide - and they go from the handle out to the tip in straight lines. That is one thing my tool Chef can do. It is also possible to go between those fazets and hits their surfaces perfectly if wanted.
I think that I have show a picture where I have change a edge 1/100 part if 1 degree, if not, you can find that picture on my homepage. I shall later se if I can make 1/1000 part of 1 degree change - just ti se if it is possible to do - and possible to see
Thomas
No, I man not a master - but I like to experiment with edges and what I can do with edges with my tools.
The picture above is from one of my experiments in precission grinding. It is 0,75 degrees angle between the fazets, the fazets are about 1 mm wide - and they go from the handle out to the tip in straight lines. That is one thing my tool Chef can do. It is also possible to go between those fazets and hits their surfaces perfectly if wanted.
I think that I have show a picture where I have change a edge 1/100 part if 1 degree, if not, you can find that picture on my homepage. I shall later se if I can make 1/1000 part of 1 degree change - just ti se if it is possible to do - and possible to see
Thomas