The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
The DILAGON: a DIY laser goniometer

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
The DILAGON: a DIY laser goniometer
Cyrano Offline
Junior Member
**
Posts: 31
Threads: 4
Joined: Jun 2018
#7
07-04-2018, 08:36 AM (This post was last modified: 07-04-2018, 08:39 AM by Cyrano.)
From several comparisons of DILAGON readings to microscopic examination, I estimate my DILAGON measurements are accurate and precise to c. 1 degree for well-behaved edges. 

This knife was sharpened yesterday with a Tormek T-8 set for 15 degrees. It read 15 degrees on the DILAGON:

[Image: i-NghGS4z-L.jpg]
Find
Reply


Messages In This Thread
The DILAGON: a DIY laser goniometer - by Cyrano - 07-01-2018, 09:23 PM
RE: The DILAGON: a DIY laser goniometer - by Cyrano - 07-04-2018, 08:36 AM
RE: The DILAGON: a DIY laser goniometer - by Jan - 07-05-2018, 01:35 AM
RE: The DILAGON: a DIY laser goniometer - by EOU - 07-05-2018, 10:33 AM
RE: The DILAGON: a DIY laser goniometer - by EOU - 07-05-2018, 01:09 PM
RE: The DILAGON: a DIY laser goniometer - by Jan - 07-05-2018, 01:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)