The BESS Exchange is sponsored by Edge On Up › BESS Forums › All About Edges v
Interesting about edge angles

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Interesting about edge angles
KnifeGrinders Offline
Knife Grinders
***
Posts: 287
Threads: 34
Joined: Oct 2017
#5
06-20-2018, 01:33 AM (This post was last modified: 06-20-2018, 04:56 PM by KnifeGrinders.)
Appreciate that Thomas, and great to know about Larrin - I wonder if he is the same Larrin who recently joined our BESS forum.

The data on edge angle obtained by Larrin in CATRA testing of the wear-resistant steel is immaculately in line with the SET testing of mainstream steels, and these two are mutually complementing.
http://knifeGrinders.com.au
Website Find
Reply


Messages In This Thread
Interesting about edge angles - by Edgepal - 06-19-2018, 07:32 AM
RE: Interesting about edge angles - by EOU - 06-19-2018, 09:43 AM
RE: Interesting about edge angles - by Edgepal - 06-19-2018, 10:18 AM
RE: Interesting about edge angles - by KnifeGrinders - 06-20-2018, 01:33 AM
RE: Interesting about edge angles - by Larrin - 06-20-2018, 05:57 AM
RE: Interesting about edge angles - by Larrin - 06-20-2018, 06:14 AM
RE: Interesting about edge angles - by Edgepal - 06-20-2018, 06:16 AM
RE: Interesting about edge angles - by EOU - 06-20-2018, 10:05 AM
RE: Interesting about edge angles - by Larrin - 06-20-2018, 12:01 PM
RE: Interesting about edge angles - by Mark Reich - 06-21-2018, 10:42 PM
RE: Interesting about edge angles - by Larrin - 06-22-2018, 04:05 AM
RE: Interesting about edge angles - by Mark Reich - 06-22-2018, 12:58 PM
RE: Interesting about edge angles - by Larrin - 06-22-2018, 04:46 PM
RE: Interesting about edge angles - by Edgepal - 06-22-2018, 06:28 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)