The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Introduction, and new Viel user

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Introduction, and new Viel user
Ken S Offline
Senior Member
****
Posts: 504
Threads: 55
Joined: Feb 2017
#21
04-20-2018, 08:30 PM
Bruin,

Noting your photo of the Viel belt and square, in a perfect world, everything would be plumb, square and level. With belt grinders, if the belt can be adjusted to track correctly (and stay that way) and the platen can be adjusted so that table is square to it, in my opinion, we are OK.

Ken
Find
Reply


Messages In This Thread
Introduction, and new Viel user - by bruin - 04-15-2018, 11:04 PM
RE: Introduction, and new Viel user - by grepper - 04-15-2018, 11:35 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 04:59 AM
RE: Introduction, and new Viel user - by EOU - 04-16-2018, 12:19 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 02:51 PM
RE: Introduction, and new Viel user - by grepper - 04-16-2018, 05:46 PM
RE: Introduction, and new Viel user - by grepper - 04-16-2018, 07:07 PM
RE: Introduction, and new Viel user - by Ken S - 04-16-2018, 07:37 PM
RE: Introduction, and new Viel user - by bruin - 04-17-2018, 12:30 AM
RE: Introduction, and new Viel user - by grepper - 04-17-2018, 09:53 AM
RE: Introduction, and new Viel user - by bruin - 04-17-2018, 11:47 PM
RE: Introduction, and new Viel user - by Ken S - 04-18-2018, 08:29 AM
RE: Introduction, and new Viel user - by bruin - 04-19-2018, 06:05 PM
RE: Introduction, and new Viel user - by grepper - 04-19-2018, 07:56 PM
RE: Introduction, and new Viel user - by bruin - 04-20-2018, 01:12 AM
RE: Introduction, and new Viel user - by Ken S - 04-20-2018, 08:18 PM
RE: Introduction, and new Viel user - by Ken S - 04-20-2018, 08:30 PM
RE: Introduction, and new Viel user - by bruin - 04-20-2018, 10:26 PM
RE: Introduction, and new Viel user - by grepper - 04-20-2018, 11:12 PM
RE: Introduction, and new Viel user - by Ken S - 04-21-2018, 07:21 AM
RE: Introduction, and new Viel user - by Ken S - 04-24-2018, 09:54 AM
RE: Introduction, and new Viel user - by bruin - 04-26-2018, 11:51 PM
RE: Introduction, and new Viel user - by bruin - 04-27-2018, 12:12 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)