The BESS Exchange is sponsored by Edge On Up › BESS Forums › Relevant General Discussion v
Surface finishing belts and deburring

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Surface finishing belts and deburring
Jan Offline
Senior Member
****
Posts: 361
Threads: 11
Joined: Mar 2017
#7
08-21-2017, 12:48 PM (This post was last modified: 08-21-2017, 01:01 PM by Jan.)
One of the possible explanations is this: different talc grades may contain significant amount of other minerals, e.g. magnesite, dolomite or quartz, which are more abrasive then pure talc.

Enjoy The Great American Eclipse today!

Jan


Find
Reply


Messages In This Thread
RE: Metal finishing belts and deburring - by Jan - 08-21-2017, 10:11 AM
RE: Surface finishing belts and deburring - by Jan - 08-21-2017, 12:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)