Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tricking the BESS Tester (without meaning to)
#7
Not to be uncaring, but on the original topic...

In my experience, it is the media tension that is most critical here. Correct me if I'm wrong - If you have it set right, the filament is slightly slack so should be able to swing and absorb any minor movement.

If however you over tension, the media is too tight and is then much easier to cut. If you really go for it, this could make readings much much lower than they should be.

Are you using the bearing version of the media clamp?
Tactical Reviews by Subwoofer
http://www.tacticalreviews.co.uk
Instagram @tacticalreviews
Reply


Messages In This Thread
RE: Tricking the BESS Tester (without meaning to) - by subwoofer - 10-19-2020, 09:14 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)