+- The BESS Exchange is sponsored by Edge On Up (http://bessex.com/forum)
+-- Forum: BESS Forums (http://bessex.com/forum/forumdisplay.php?fid=1)
+--- Forum: Relevant General Discussion (http://bessex.com/forum/forumdisplay.php?fid=19)
+--- Thread: Belt grinder...Vertical vs Horizontal (/showthread.php?tid=431)
Belt grinder...Vertical vs Horizontal - SHARPCO - 01-21-2019
[attachment=817]
Vertical.
Maybe most of you are using Kally vertically.
[attachment=816]
Horizontal
When I sharpen knives on the slack belt, I set it horizontally. I like it because I can see that removing of burr during edge is on the belt.
But there is one inconvenient thing, replacing the belt is a little cumbersome.
And I think the vertical type is better when using Platen. Because I have to see the edge and belt contact.